Skip to main content

CVE-2026-99346Linux vulnerability

Low priorityNot scoredEPSS not scored yet

CVE-2026-99346 is a vulnerability in Linux, not yet scored.

Why this priority: Not scored yet, and no exploitation signal.

Published · Updated · NVD status: Received

What it is

The record does not classify the weakness yet; the description below says what the reporter found.

How it is reached

The record does not say yet how the flaw is reached; the description below is the best guide until it is scored.

What an attacker gains

Its impact has not been scored yet.

Is it being exploited?

There is no public report of exploitation yet.

What to do

  1. Upgrade Linux to a fixed version for your release line (6.12.117, 6.18.61, 7.3.2).

Description from NVD

In the Linux kernel, the following vulnerability has been resolved:

KVM: SVM: Trigger new ASID allocation in both VMCBs on pCPU switch

When the pCPU where the VMCB was most recently used is switched, reset the ASID generation in both VMCBs, triggering new ASID allocation for the immediate VMRUN as well as the next VMRUN on the other VMCB.

The ASID is shared between vmcb01 and vmcb02, and gets flushed on every nested transition. However, since pCPU tracking is done per VMCB, it is possible for one VMCB to allocate a new ASID when migrated to a new pCPU, and then the other VMCB reuses that ASID on the old pCPU. This can result in the same ASID being used by multiple vCPUs on the old pCPU.

Example scenario: - vCPU runs on pCPU A, vmcb01 is active, asid=1. - vCPU migrates to pCPU B, vmcb01 pCPU changes, new asid=2. - Another vCPU runs on pCPU A and allocates asid=2 as well. - vCPU migrates back to pCPU A, and then switches to vmcb02 before it runs again with vmcb01. - No pCPU switch is detected for vmcb02, so VMRUN is done with asid=2. - Two vCPUs end up using asid=2 on the same pCPU.

Keep the VMCB dirtying to the active VMCB only. Clean bits are tracked by a pCPU for each VMCB, so do not unnecessarily dirty a VMCB if its pCPU does not change.

Additionally, initialize the tracked pCPU for vmcb02 to -1 on nested enablement as hardening, so that a new ASID allocation is always triggered when nested is disabled and re-enabled.

No performance regression was noticed when overcommitting L1 vCPUs in L0 (to force rescheduling), pinning L1 <-> L2 vCPUs, and running CPUID in a tight loop bouncing between 2 vCPUs in L2.

An alternative (and perhaps more proper) fix would be tracking the ASID per-VMCB instead (e.g. [1]). However, that's a more involved change, and it would result in having different ASIDs for L1 and L2 without actually properly maintaining them. It would probably work because all TLB flushes target the current VMCB, and the other VMCB is always flushed on nested transitions, but the code ends up in an arguably more fragile state. Punt a proper clean fix to an incoming (and overdue) overhaul of SVM's ASID usage [2].

[1] https://lore.kernel.org/lkml/20250205182402.2147495-2-yosry.ahmed@linux.dev [2] https://lore.kernel.org/kvm/20260728003557.1136583-1-yosry@kernel.org

What this means for your architecture.

A CVE names a product. Whether it matters depends on where that product sits in your systems: what reaches it, which trust boundary it guards and what it can reach once compromised. Veriom maps your components, their relationships and your trust boundaries from your code, cloud and delivery evidence, so you can see where a component like this sits. The radar itself does not look at your systems.

Components it touches

  • Linux. Start from where it runs and what it is connected to.

Trust boundaries in play

    Questions to answer about your own systems

    • Where does Linux run in your systems, and at which version?
    • Which of those instances are reachable by people you do not trust?
    • What can it reach once compromised: which data stores, secrets and services?

    14-day free trial

    Understand how your systems connect.

    See your services, dependencies and trust boundaries in one place, with evidence from your connected environment.

    Sources

    • CVE records and CVSS scores from the NVD CVE API. This product uses the NVD API but is not endorsed or certified by the NVD.
    • Exploitation status from CISA’s Known Exploited Vulnerabilities catalog.
    • Exploit likelihood from FIRST’s Exploit Prediction Scoring System (EPSS), refreshed daily.
    • Explanations are written by Veriom from fixed templates over each record’s data, not by a person reviewing each CVE. Descriptions are quoted from the records as published.